Pin shackle A pin shackle is closed with a clevis pin. Primarily used above the deck, pin shackles used to be the most common shackle used aboard boats. Pin shackles can be inconvenient to work with at times because they are secured using something else, usually a split pin or seizing wire. Threaded shackle A moused shackle The pin is threaded and one leg of the shackle is tapped. The pin may be captive, which means it is mated to the shackle, usually with a wire. The threads may gall if over-tightened or have been corroding in salty air, so a liberal coating of lanolin or a heavy grease is not out of place on any and all threads. A shackle key or metal marlinspike are useful tools for loosening a tight nut. For safety, it is common to mouse a threaded shackle to keep the pin from coming loose. This is done by looping mousing wire through the hole in the pin and around the shackle body. For pins that have a cross-hole in the threaded end a cotter pin can be used. One disadvantage is that mousing can introduce galvanic corrosion because of material differences; it is especially bad when used in places where the shackle is exposed to air and water. Snap shackle A snap shackle spliced to a line. As the name implies, a snap shackle is a fast action fastener which can be implemented single handed. It uses a spring activated locking mechanism to close a hinged shackle, and can be unfastened under load. This is a potential safety hazard, but can also be extremely useful at times. The snap shackle is not as secure as any other form of shackle, but can come in handy for temporary uses or in situations which must be moved or replaced often, such as a sailor's harness tether or to attach spinnaker sheets. Note: When this type of shackle is used to release a significant load, it will work rather poorly (hard to release) and is likely to have the pin assembly or the split ring fail. D-shackle Also known as a chain shackle, D-shackles are narrow shackles shaped like a loop of chain, usually with a pin or threaded pin closure. D-shackles are very common and most other shackle types are a variation of the D-shackle. The small loop can take high loads primarily in line. Side and racking loads may twist or bend a D-shackle. Headboard shackle This longer version of a D-shackle is used to attach halyards to sails, especially sails fitted with a headboard such as on Bermuda rigged boats. Headboard shackles are often stamped from flat strap stainless steel, and feature an additional pin between the top of the loop and the bottom so the headboard does not chafe the spliced eye of the halyard. Twist shackle A twist shackle is usually somewhat longer than the average, and features a 90° twist so the top of the loop is perpendicular to the pin. One of the uses for this shackle include attaching the jib halyard block to the mast, or the jib halyard to the sail, to reduce twist on the luff and allow the sail to set better. Bow shackle With a larger "O" shape to the loop, this shackle can take loads from many directions without developing as much side load. However, the larger shape to the loop does reduce its overall strength. Also referred to as an anchor shackle.